How to install led light belt indoors and outdoors?
Published by Publisher: adminDate: 6/20/2024 9:08:52 PM Read: The first kind, led light belt indoor installation LED light belt for interior decoration, because do not have to withstand the wind and rain, installation is considered to be beautiful and generous, led light belt installation plays a role in decorating the existing engineering site, so the installation is very simple. There is a self-adhesive 3M double-sided adhesive on the back of each LED lamp belt wholesale of our led light belt.
During installation, you can directly tear off the sticker on the surface of 3M double-sided glue, then fix the lamp strip where you need to install it, and press it flat with your hand. As for some places that need to turn the corner or the led light belt has grown how to do? Very simply, the LED light belt is a series-parallel circuit structure consisting of a group of three LED. Every three LED can be cut off and used separately. How long to use, it can be subtracted. Notice that the pad is subtracted.
Second, led lamp belt outdoor installation led lamp belt outdoor installation pays more attention to the waterproof of the lamp belt and the firmness of the installation. The reason for this installation of led light belt, mainly due to the wind and rain, if the use of 3M glue fixed for a long time will cause 3M stickiness to reduce and cause LED light belt to fall off, so outdoor installation often use card slot fixed way, need to cut and connect the place, the method and indoor installation, but need to be equipped with additional waterproof glue to consolidate the waterproof effect of the connection point.
Then it is fixed with a special fixing clip, which can be punched with an electric hammer and fixed with a plastic expansion tube and screws.
Pay attention to the connection distance of LED lamp belt, generally speaking, the longest connection distance of 3528 series LED lamp belt is 20 meters, and the longest connection distance of 5050 series LED lamp belt is 15 meters. If the connection distance is exceeded, the LED lamp belt is easy to heat, and the service life of the LED lamp belt will be affected during use. Therefore, the installation must be in accordance with the requirements of the manufacturer to install, do not let the LED lamp run with overload. The third point, the connection method of LED lamp belt (power connection) the general voltage of LED lamp belt is DC 12V, so it needs to be supplied by switching power supply, and the size of the power supply is determined according to the power and connection length of the LED lamp belt. The connection method of monochromatic 5050 chip LED lamp strip is shown below, which distinguishes the positive and negative electrodes. Generally, we provide a welded power plug, which is directly plugged into the lamp belt power supply we provide. If you do not want each LED lamp belt to be controlled by a power supply, you can buy a switching power supply with relatively high power as the total power supply. Then all the LED lamp input power supplies are connected in parallel (if the wire size is not enough, it can be extended separately), which is supplied by the main switching power supply. The advantage is that it can be controlled centrally, and the inconvenience is that the lighting effect and switch control of a single LED light belt can not be realized, which way can be measured by oneself. If you use a large power supply, the controller connection mode LED racing light belt and RGB magic light belt need to use the controller to achieve the magic effect, when wiring, the magic light belt is generally co-anode, that is, one of the lamp belt is 12V and the other are negative RGB three negative electrodes, such as the above figure wiring and the control distance of each controller is different, generally speaking, the control distance of the simple controller is 10 to 15 meters. The control distance of the remote controller is 15 to 20 meters, and the maximum distance can be controlled to 30 meters. If the connection distance of the LED light belt is long, and the controller cannot control the long light belt, then you need to use a power amplifier for the tap.
